Outer Limits 4x4 Board

Thanks for that. I'm not sure that the brackets are the same. I have a picture on specter off road, but it's an exploded diagram, and the picture is tiny.

The part that I specifically need a photo of I have found on this page: http://www.sor.com/sor/cat118.tam?xax=3270&page%2Ectx=cat118%2Etam ...

Hi everyone,
I am in the process of restoring my 1978 FJ40, and I am up to mounting the front bucket seats, however the previous owner made up some hack job "custom seat brackets", and because of this I am not entirely sure as to what all of the original brackets actually look like. I have a few of ...

Jonno

What series cruiser do you have, and do you have any photos?

Cheers,
Ian

Just had a look at my engine, and I've realised how low it sits- the chop that I'd have to do would be quite a lot lower than the link that I posted before.

This is my engine as it stands at the moment. The tub is not actually connected to the chassis, it is resting just out of position.
http ...

Hi Daniel,
I have a 40 series Landcruiser and also went the Dellow route, but it's fouling on my firewall as well (very similar to yours with the rocker covers).
I plan to chop the firewall slightly- Has anyone gone down this path before? (I'm sure someone has)
Can you give any tips or advice on ...

Hi I'm wondering if there is anyone (or anyone recommended) in Adelaide who wire up the Holden to the Toyota
Cheers
Ian

I am currently doing a V8 conversion on my FJ40, and i'm needing some slightly more detailed information than what is in the common workshop manuals.

I was wondering if anyone has or knows where to find a "works manual" for a holden commodore vr- vs v8 engine (the one with more detailed info ...

Edited

Hi all

I'm currently in the middle of converting a FJ40 to a holden 308 v8, and i was wondering if there are any problems withusing the OEM thrust bearing with the new holden clutch.

The diameter of the OEM clutch thrust bearing/ throw out bearing (where it contacts the pressure plate) is ...